Test And Measurement Products

  1. Narda's New NBM Series Of Meters And Probes
    2/6/2007
    Narda has released the new NBM series of meters and probes. Based on years of market leadership and innovation, this new series features improved field probes and the NBM-550 meter with its incredible display, comprehensive software, and even optional GPS...
  2. dB-3906 TWT Amplifier
    5/1/2015

    The dB-3906 TWT Amplifier (TWTA) is designed to use two wideband, periodic permanent magnet (PPM)-focused TWTs to amplify CW, AM, FM or pulse-modulated signals. The dB-3906 offers higher saturated output power and improved harmonic performance when compared to a single TWT approach.

  3. Phase Noise Measurement Analyzers
    2/15/2011
    Holzworth Instrumentation was founded as a phase noise measurement company. Along the path to phase noise analysis solutions, our high performance building blocks were developed and sold in the form of RF Synthesizers, Phase Detectors, etc. The HA7401A is a Fixed Frequency Phase Noise Analyzer, and the HA7402A is a Phase Noise Measurement Engine.
  4. Low Noise Synthesizer: LNS-18
    9/12/2012

    The LNS-18 Low Noise Synthesizer is ideal for use as a signal source for driving up- and down-converters in military, space, and other applications where phase noise is critical. This is due to the fact that this particular synthesizer features the lowest phase noise of any product like it on the market today.

  5. Solid State Matrices: 3206 Thru 3211
    4/26/2010
    A new switch matrix series with either 50-ohm or 75-ohm impedance is available from small scaled 8x8 full fan-out configuration up to large scaled 128x128 matrix.
  6. Wideband Area Monitor: AMB-8059
    5/8/2015

    The new AMB-8059 Area Monitor is designed to monitor electromagnetic field levels in accordance with the ITU-T Recommendation K.83. The monitors can be equipped with various probes that can capture electric field strengths in the 100kHz to 7GHz frequency range.

  7. Switch Matrix: R&S® ZN-Z84
    11/12/2013

    The R&S® ZN-Z84 is a 48-port solution designed to complement the R&S ZNB network analyzer. It’s used to test multiport components for the wireless communications market in R&D and production phases. The matrix covers the 10 MHz to 8.5 GHz frequency range and can be controlled and operated directly from the ZNB network analyzer.

  8. Compact Integrated Microwave Test System: Model 7700
    9/12/2012

    The 7700 is a bench-sized integrated microwave test system designed to reduce production costs by eliminating the need for multiple test instruments, ATE development cost, and ongoing maintenance. This one system provides the functionality and measurement capabilities of a vector signal generator, spectrum analyzer, vector network analyzer, oscilloscope, power meter, frequency counter, noise figure meter, and a phase noise analyzer.

  9. Digital Signal Booster: 614 Series
    11/19/2015

    The 614 Series Digital Signal Booster is a TX RX system from Bird Technologies designed to operate in the UHF frequency band. Digital filters are available for both uplink and downlink, and are user programmable from 6.25 kHz to 1.5 MHz. Other filter center characteristics are fully programmable in order to meet various system and signal demands.

  10. Phase Noise Analyzer And VCO Tester: R&S®FSWP
    4/16/2019

    Rohde & Schwarz’s R&S FSWP phase noise tester can measure the spectral purity of signal sources such as generators, synthesizers and voltage-controlled oscillators (VCO) more quickly than with any other solution. The high-end instrument covers a frequency range up to 50 GHz and offers a top dynamic range. It features an extremely low phase noise of its local oscillator coupled with cross-correlation that makes it possible to easily measure signal sources that in the past required complex test setups or could not be measured at all.